Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
1. Open the Hood.
2. Important: Make sure control knobs are turned “Off”.
(FIG. 17B)
3. Turn the LP Gas Cylinder valve open counter
clockwise until it stops. (FIG. 17A)
4. Push far left control knob in and turn counter
clockwise to the High position. (FIG. 17C &17D)
5. Pause 4 seconds and push the ignitor button in for
2-3 seconds to light the burner. Listen for the spark
ignition and look to make sure the burner is lit.
If no spark, see (FIG. 17E) and T
roubleshooting
Section.
6. From the “Off” position, light all other burners from
left to right, making sure each burner is lit before
lighting the next. Your grill has a crossover ignition
system that allows the burners to light successively
off one another. Confirm each burner is lit before
lighting another burner.
7. If the burner fails to light, repeat Step 3. If it still does
not light, try the next burner from left to right.
If a burner goes out during operation, turn all knobs to
the “Off” position and close the LP cylinder valve or
the natural gas supply valve to dissipate any
accumulated gas. Open hood and wait five minutes
before attempting to relight the grill.
If any or all burners fail to light after three or four
attempts following Steps 4-7, turn all knobs to the
“Off” position and close the LP gas cylinder valve to
dissipate any accumulated gas. Wait five minutes; then
repeat the lighting procedures. NOTE: If the burners
still fail to light, refer to the T
roubleshooting Section.
The burner can also be lit manually, see Manual
Lighting of the Grill.
LIGHTING THE GRILL USING
THE PULSE-SPARK IGNITOR
To reduce the risk of serious bodily injury or death:
· Open Hood before lighting the grill to prevent an
explosion from gas build-up.
· During failed lighting attempts, or if the burners go out
during operation, turn control knobs “Off” to dissipate
any accumulation of gas. Wait five minutes before
repeating lighting procedure.
Left Control Knob
Right Control Knob
Ignitor Button
Lighting with Ignitor
FIG. 17E
Gas Collector Box-If
no spark, pinch
together or open Gas
Collector Box to
adjust 3/16” gap
between electrode tip
and V-notch.
FIG. 17C
3/16” Gap
16
FIG. 17B
FIG. 17D
Control Knob on
High position
(large flame
symbol)
FIG. 17A
Control Knob
in OFF
position
Turn LP Gas Cylinder
valve counter-clockwise.