Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Wire is shorting (sparking
between ignitor wire and
electrode
Replace ignitor wire/electrode assembly (Call the Customer
Service Department @ 1-800-251-7558)
13
Problem
Possible Cause
Solution
Burner will not light
using the ignitor
Burner not assembled
correctly
Not pausing long enough
before clicking the Igniter
No spark
LP gas cylinder is empty
Excess flow valve tripped in
Regulator
Obstructions in burner
Electrode and burner are wet
Wire is loose or disconnect-
See Assembly Instructions
for installing the Burner.
The spacing between electrode and Burner ports should be
approximately 3/16”. Make sure wire connections are secure
and burner is attached securely to brackets.
Dispose of empty cylinder and replace with a full one.
Turn Control Knob to “OFF” position. Wait five minutes. Relight
LP gas grill. If flame remains to be low, turn off gas.
Disconnect the Lp gas cylinder from the Regulator. Reconnect
the LP gas cylinder to the Regulator. Perform a leak test.
Relight grill. This will reset the excess flow valve.
Clean burner (See Burner Maintenance in Care and
Maintenance section of this manual)
Dry electrode with clean cloth
Reconnect the wire
TROUBLESHOOTING
When lighting the Burner, push in and turn the Control Knob
counterclockwise to “I” when you feel resistance. Pause 4
seconds, then push in and turn the Control Knob until a click is
heard.
Your Gas Grill comes with convenient wheels and a slide
out handle for roll-away transport. When the Grill has
completely cooled, and the Grill and all the parts are clean:
· Disconnect the LP cylinder from the regulator.
· Fold and strap the Grill side tables over the closed Hood.
· Slide the Left Handle Bar back under the grill.
· Remove the leg shelf. Release the locking springs and
lower the left end of the Leg Shelf. Lift the other end off
the mounting Hooks on the right legs.
· Swing the Gas Regulator up into its storage position
behind the front panel of the Grill and clip it into place.
(FIG. 24)
· Fold Legs to locked position under Grill.
· Store Leg Shelf back in the bottom of the grill and snap
into place.
· Grasp the Right side Handle Bar; lift Grill on wheels and
roll the grill away to storage area. (FIG. 25) DO NOT
ATTEMPT TO CARRY THE GRILL BY GRASPING THE
HOOD HANDLE
Store Gas Regulator & Hose
Fig. 24
Fig. 25
Tow-away on Wheels
For Convenient Storage
GRILL MOVING AND STORAGE
· Do not store the Grill unless it has cooled down and
has been cleaned.
· Always Lock the Grill Hood with the Strap Lock
before moving and storing this Grill.
· To avoid possible injury, be careful when rolling your
grill so it does not roll up against you.
Use Slide Handle
Bar for Towing
Storage Clip