Meco 2200 Gas Grill User Manual


 
11
FIG. 23A
5-Screws Securing Control Panel
FIG. 23B
5) Control Valve
Spring Clip
FIG. 23E
9) Use a pipe cleaner to clear obstructions from all
burner holes and the Inlet hole. A brass wire brush can
be used on the burner surfaces to remove corrosion.
Oval Burner
Chain/Match
Holder
Control Panel
Grid Insert
Guide
FIG. 23C
6) Electrode Spring Clip
FIG. 23D
CAUTION: SOME OF THE METAL EDGES MAY BE
SHARP. BE CAREFUL IN HANDLING.
How to Clean the Burners
1) Make sure the Grill Control Knobs are turned to the
“OFF” position, and the grill has completely cooled.
2) Disconnect the LP cylinder.
3) Remove Grease Cup, Cooking Surfaces and Leg Shelf.
4) Pull the Control Knobs off the valve stems. Remove: 5-
screws, Grid Insert Guide, Control Panel and the
Chain/Match Holder. (FIG. 23A)
5) Remove 2-Control Valve Spring Clips with screwdriver.
(FIG. 23B)
6) Remove Ignitor Wire Spring Clip by holding end of clip
with pliers and pushing down away from the notch in
burner bracket. (FIG. 23C) Hold spring with fingers so
clip does not flip away.
7) Lay grill on the back side. Remove 5-screws holding
the Burner Brackets to underside of Bowl. (FIG. 23D)
8) Remove both Burner Assemblies from the grill.
9) Use a pipe cleaner to clear obstructions from the
Burner holes and inlet hole. (FIG. 23E & FIG. 23F)
Verify that there are no insects or insect nests blocking
the inlet hole. Normal wear and corrosion may enlarge
some holes, however, if large cracks or holes are found
the Burners should be replaced.
10) After cleaning, re-assemble Burner Assemblies and
other parts in reverse order of previous Steps 2-9
disassembly. Note: When refitting the Burners, be sure
the tubes are positioned correctly with the valves.
11) Check burner operation after reassembly or cleaning.
Round Burner
FIG. 23F
7) Remove 5-Screws from Burner Brackets
under Grill bottom.
CARE AND MAINTENANCE
· Check the LP gas grill for gas leaks and Burner
obstructions before each use.
· Always turn off the Control Knobs when not in use.
Allow grill to cool before handling parts or cleaning.
Burner Maintenance
Burners should be removed and cleaned annually, or
whenever heavy build-up is found, to ensure that there are
no signs of blockage (debris, insects) in either the burner
portholes, the primary air inlet, or the neck of the burners.
(See Burner cleaning instructions next page.)