KitchenAid KBNU367T Gas Grill User Manual


 
29
ROTISSERIE SPIT ROD AND FORKS
Cleaning Method:
Wash with mild detergent, using a soft cloth and warm water.
Rinse and dry.
For stubborn areas, use a multi-purpose cleaner, a heavy-
duty scrub sponge or mild abrasive cleaner.
DRAWERS
Cleaning Method:
Routine cleaning
Paper towel and spray glass cleaner:
Make sure drawer is cool. Follow manufacturer’s instructions.
Warm, soapy water or all-purpose cleaner and a nonabrasive,
plastic scrubbing pad:
Wash, wipe with clean water and dry thoroughly.
Stubborn stains and baked-on residue
Rub in direction of grain to avoid damaging.
Mildly abrasive cleanser or stainless-steel cleaners and a
damp cloth or sponge.
Wash, wipe with clean water and dry thoroughly. Repeat if
necessary.
RACKS
Cleaning Method:
Steel-wool pad and warm, soapy water:
Wash, rinse and dry thoroughly.
Drawer Slides
The drawer slides allow you to fully extend the drawer for easier
cleaning. If necessary, the drawer can be removed.
NOTE: Load capacity for the drawer and slides is 100 lbs (45 kg).
Drawer Removal
Remove all items from inside the warming drawer, and allow the
warming drawer to cool completely before attempting to remove
the drawer.
To Remove:
1. Open drawer to its full open position.
2. Locate the black tabs on both sides of the drawer.
3. Press the tab down on the right side and lift tab up on the left
side at the same time, then pull drawer out another inch to
disengage latch.
4. Hold the drawer by its sides (not by its front). Pull it slowly all
the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the guides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Is the main or regulator gas shutoff valve in the off
position?
See Installation Instructions.
Is the grill properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.
Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
A.Tab
A
A.Drawer glides
B.Receiving guides
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING