Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
6 GRB 32231 - 111026
Assembly page 6/32
Fax +32 2 359 95 50
BEFORE FIRST USE
• Before using the grill for the first time, it’s a good idea to assemble it fully
indoors, to check that you’ve got all the parts and that they’re all in the
right places.
• Clean the grill and all the accessories (Cf. "Cleaning and care"). It is
recommended to heat up the grill for about 10 minutes without any
foodstuff in order to eliminate the grease that may have adhered
during manufacture and the "new" smell.
• Ventilate the room during this period or use outside.
ASSEMBLY
• Align the power inlet on the grill plate with the recess in the side of the
grill housing, and lower the grill plate into the top of the grill housing.
• The feet underneath the grill plate will rest on 4 specially strengthened
points inside the grill housing.
• The tab in the middle of the recess will go through the slot underneath
the power inlet, and push up the cover inside the power inlet to expose
the earth socket inside the power inlet.
• The earth contact protruding from the temperature control fits through
the hole in the tab, and into this socket.
• If the grill plate is not properly fitted in the grill housing, you will not be
able to fit the temperature control to the grill, and the grill will not
function. This is a safety feature. Do not try to overcome it.
• Do not try to use the grill plate on its own. It must only be used with the
grill housing.
• Push the drip tray into the gap on the front of the grill housing.
• Check that it is placed under the holes in the grill plate.
• If you’re not using the stand, sit the grill housing on a stable, level, heat-
resistant surface.
NOTE: If you’re not using the stand, miss out the next assembly points
• Use the screws supplied to attach the 3 stabilizers to the bottom of the
stand.
• The stabilizers fit into the gaps between the legs of the stand to form a
circle at the base
• Put the stand on a stable, level surface.
• To fit the mp3 holster, push the narrow end of the tube through the hole
in the removable holster.
• Fit the narrow end of the tube into the hole in the top of the stand, so
that it engages with the screw inside the stand, and then turn the tube
clockwise to tighten it.
• Don’t over-tighten it – finger tight is sufficient.