Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Outdoor Lifestyles by Hearth & Home Technologies Inc. • 4070-300 Rev C • 4/11
12
4
Installation of Fireplace
Position the Fireplace
This replace may be placed on either a combustible
or noncombustible continouous at surface. Follow the
instructions for framing in Section 3.D. Slide the replace
into position. Be sure to provide the minimum air clear-
ance at the sides and back of the replace assembly. See
Section 3.B.
FIre Risk!
Prevent contact with sagging, loose
insulation.
Do NOT instal against vapor barriers or
exposed
insulation.
Cooling Air Hoods must be installed if
instaling
on a combustible surface.
WARNING
Level the replace side-to-side and front-to-back. Shim with
noncombustible material, such as sheet metal, as neces-
sary. Secure the replace (using the nailing anges located
on either side of the replace) to the vertical framing.
Protective metal strips are placed 2 in. (51 mm) under the
front of the fireplace and must extend beyond the front
and sides of fireplace opening by 2 in. (51 mm).
1 in. (25 mm)
overlap
Figure 4.1 Position the Protective Metal Hearth Strips
Raised Platform
Floor
2 in.
(51 mm)
1 in. (25 mm) min.
overlap
2 in.
(51 mm)
Top piece must overlap
bottom piece
Figure 4.2 Protect the Front of an Elevated Platform
Note: When elevating the fireplace above the hearth
extension the front of the elevated platform must be
protected with a protective metal hearth strip.
Important: To ensure proper t of the glass doors, check
the fireplace opening for square. Measure diagonal
distances of the opening to make sure they are equal.
If they are not, continue to shim the replace until those
diagonals are equal.
• Place the Protective Metal Hearth Strips
Fire Risk!
• Metal hearth strips MUST be installed.
Sparks or embers may ignite ooring.
WARNING
Included with your replace you will nd two metal hearth strips
measuring approximately 26 in. x 4 in. (660 mm x 102 mm).
These strips are used to provide added protection where the
replace and the hearth extension meet when installed on
a combustible service.
Slide each metal strip 2 in. (51 mm) under the front edge of
the replace. The individual pieces must overlap each other
by 1 in. (25 mm) minimum in the middle of the replace to
provide continuous coverage of the oor. See Figure 4.1.
These metal strips should extend from the front and sides of
the replace opening by 2 in. (51 mm).
A. Secure the Fireplace
Level the Fireplace