Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Assem
ly Step 4
Ignitor Knob
Control Knob Control Panel
Assembly
i!
1. Leave the cabinet upside down.
2. Attach the Ignitor Knob and the Control Knob
to the control panel as shown. Make
sure the Control Knob properly
seats on the keyed shaft.
3. Line up the control panel as
shown.
iiiiiii
Screwdriver
4. The HVR stem must be inserted
into the venturi as shown in
Figure 1 on the following page.
5. When sliding the control
panel into place, make sure
the tabs capture the legs
as shown in Figure 2 on
the following page.
6. Connect the ignitor wire to one
of the prongs on the ignitor as shown
in Figure 2 on the following
page.
7. Insert the 2 remaining bolts from
Hardware Bag A through the tabs
on the Control Panel and thread
them into the mounting holes.
8. Firmly tighten all of the bolts
and nuts.
9. Carefully turn the smoker
upright onto its legs.