Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Lighting Procedure
Ignitor Lighting System:
1. Check all connections for leaks using the "soapy water" test
as explained on page 17.
2. Open the smoker cabinet door.
3. Check for any blockage to the venturi tube or burner.
Remove any foreign objects or matter.
4. Be sure the burner control knob is in the "OFF" position.
5. Open the LP cylinder valve 1 ½ turns by turning counter-
clockwise.
.
.
To light unit with the rotary ignitor, push in and turn the
burner control knob counter-clockwise to the high setting.
Immediately rotate the ignitor knob clockwise until you hear
it click several times (you should see a small spark jumping
from the end of the electrode rod to the side of the burner).
If the burner doesn't light within 3 to 5 seconds, turn the
burner control knob off and wait five minutes before
repeating the steps again. If burner still fails to light try
match lighting the smoker using the instructions noted
below.
.
Once the burner is lit, then close the door to allow heat to
accumulate. The dampers can then be adjusted to the
desired setting to allow proper air flow and combustion.
Damper adjustment tips are listed on the next page.
Match Lighting"
1. Repeat steps 1 thru 5 of the Ignitor Lighting System above.
.
Remove the Wood Chip Box and its stand from inside the
smoker. Light a paper match and drop it into the burn
chamber, making sure it falls next to the brass burner.
Quickly turn the control knob to the light position. If the
burner does not light within 4 or 5 seconds, turn the control
knob off, wait 5 minutes, and repeat the process.
2O