Fisher & Paykel BGB36 Gas Grill User Manual


 
STAINLESS STEEL:
The grill is made from non-rusting and non-magnetic stainless steel. After initial usage, areas of the grill may
discolour from the intense heat given off by the burners, this is normal. There are many different stainless steel
cleaners available. Always use the mildest cleaning procedure first, scrub-
bing in the direction of the grain. To touch up noticeable scratches in the
stainless steel, sand very lightly with wet 100 grit emery paper in the direc-
tion of the grain. Specks of grease can gather on the surfaces of the stain-
less steel and bake on to the surface and give the appearance of rust. For
removal use an a mildly abrasive pad in conjunction with a stainless steel
cleaner. Always rub in the direction of the grain.
Note:
Stainless steel tends to corrode in presence of chlorides and sulfides especially in
coastal areas. To ensure corrosion prevention, wash all stainless steel surfaces
every 3-4 weeks with fresh water and stainless cleaner. Keep grill covered when
not in use.
SIDE BURNER IGNITORS:
Wipe with a water dampened cotton swab. Be careful not to damage the
ignitor (see Fig. 50).
TO REMOVE THE GRILL BURNERS FOR CLEANING
1. Ensure the burners have cooled and the gas supply has been turned off at the
cylinder valve or shut-off valve.
2. Remove the grill grates, then lift out the radiant trays and grease shields
(Fig. 51).
3. Using a Phillips screwdriver, unscrew the clamps holding the burners in
place on either side Fig. 52. Put the clamps and screws safely aside.
4. Grasp the curved section of the burner in the rear and gently pull up to
release the securing tabs from the rear support bracket.
5. Move the burner slightly away from you so as to slide it out from the collector
box and disengage the burner inlet from the injector inside the valve
hole in the front (Fig. 54).
6. Angle the burner sideways and lift out.
FIG. 50
FIG. 51
FIG. 52
FIG. 53
FIG. 54
Ignitor (KEEP CLEAN)
CARE AND MAINTENANCE
Burner clamps
Collector box
Burner inlet
Radiant
tray
Grill grate
Grease
shield
Valve
hole
38