Fisher & Paykel BGB36 Gas Grill User Manual


 
30
TO LIGHT THE ROTISSERIE BURNER BEFORE COOKING:
The location of the rotisserie burner makes it more susceptible to strong wind conditions, more so than the
protected grill burners. For this reason you should avoid operating the rotisserie during windy conditions. As an
added safety feature we’ve equipped the burner with an automatic safety valve which will not allow gas to flow
to the rotisserie burner unless the following conditions are present with the knob on:
1. The safety valve button is pressed, and held down.
2. The safety valve thermocouple has been sufficientlyheated to keep safety valve open.
Open the hood. Push and hold the ignition button. You’ll hear a snapping sound. Turn the control knob to “HI”.
Engage the safety valve button and continue to hold until the burner is lit. Once lit, turn control knob to desired
setting. If the burner does not light within 4 to 5 seconds, release the safety valve button and turn the control
knob to “OFF” and wait 5 minutes before trying again.
If relighting a hot burner, wait 5 minutes.
Never leave the control knob on if rotisserie is not in use.
Never light a grill burner under the rotisserie while rotisserie burner is lit.
MANUAL LIGHTING:
To manually light the rotisserie, place a butane lighter near
the tip of the thermocouple as shown in Fig. 41. Turn the
control knob to “HI”. Hold the safety valve button in for
about 4 to 5 seconds or until the burner remains lit. Once
lit, turn control knob to desired setting. If the burner does
not light within 4 or 5 seconds, release the safety valve
button and turn the control knob to “OFF” and wait 5 min-
utes before trying again.
WARNING!
Keep hands and face away from front of burner! STAND TO
THE SIDE WHEN LIGHTING. ONCE LIT MOVE HAND AWAY
QUICKLY.
WARNING!
Electrical Grounding Instructions: This appliance (rotisserie motor) is equipped with a three-prong (grounding) plug
for your protection against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle or a three-prong grounded extension cord rated for the power of the rotisserie motor and approved for
outdoor use. Do not cut or remove the grounding prong from this plug. Use only a residual current device (RCD)
protected circuit.
The rotisserie motor must be electrically grounded in accordance with local codes. The rotisserie motor should
be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30
mA. Keep the rotisserie motor electric cord away from the heated surfaces of the grill. When not in use, remove
and store the motor in a dry location. To protect against electric shock, do not immerse the cord or plug in water
or other liquid. Unplug rotisserie unit from the outlet when not in use and before cleaning. Allow the rotisserie to
cool before putting on or taking off parts.
Thermocouple
USING THE ROTISSERIE
FIG. 41