Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
OPERATNG YOUR BARBECUE
To extend the life of your Fire Magic Barbecue, follow these
steps prior to cooking:
1. Begin by heating the unit at a normal cooking temperature
for several minutes.
2. Then open the Control Valves to the “High” setting to burn
off residue remaining from prior use.
3. When the Barbecue has heated sufficiently, set heat to the
desired cooking level.
4. When using a smoke oven, closing the cover during the
preheat period will accelerate the preparation process. DO NOT
operate unattended at High Flame as cooking temperatures
will quickly be exceeded.
Using Your Optional Backburner
Rotisserie cooking with the Backburner is accomplished without
use of the main grill Burners. The cooking grids are removed
and if large cuts are to be barbecued, the Flavor grids may be
removed to allow more clearance from the spit rod to the fire
box. Aluminum Foil or a baking pan may be placed over the
main Burners to catch excess drippings from your cooking.
a. Remove the Backburner cover. (Fig.13)
b. Place your meat on the rotisserie spit rod. Make sure it is
centered on the spit. Refer to the instructions provided with
your Fire Magic Rotisserie and counter balance.
c. Follow the lighting instructions on page10
d. Allow the Backburner to preheat for approximately 10
minutes on "HIGH" setting.
e. Place the spit rod with the meat into the rotisserie and turn
on the motor.
f. Use a standard roasting guide to estimate the length of time
for your meat. A meat thermometer may also be used to tell
when your favorite cuts are cooked to your liking. When testing
temperatures with a thermometer, turn off the rotisserie motor
and turn the Backburner on "Low". This will keep the meat from
over cooking on one side
g. Operate your Backburner with the oven closed. This will
simulate an oven effect and help your meat cook faster. The
constant rotation of the spit assures even cooking and maximum
retention of juices.
h. On large cuts of meat or whole turkeys, it may be necessary
to reduce the heat from your Backburner. Cooking your food at
lower temperature for a longer period will keep the outer surface
from burning, while cooking the interior of your food thoroughly. `
Figure 13
WOODCHIP BOX
BACKBURNER COVER
AIR SHUTTER
SCREW POSITION
BACKBURNER
Smoker Tray (Woodchip Box)
Your Backburner is supplied with a woodchip box. The
woodchip box is designed to sit on top of the Backburner
assembly over the notch in the heat deflector (See Fig. 13).
This box is designed to be used when the Backburner is in use.
To use the box, just fill it with your favorite woodchips and set
it in place. If you wish to refill the woodchip box when it is hot,
you may carefully handle it using a pair of pliers. You must be
very cautious not to get burned.
The Backburner Cover
a. The Backburner cover is installed by placing the curved part
of the cover over the top of the perforated portion of the
Backburner (See Fig. 13).
b. The cover should be kept in place on the Backburner when
it is not in use. This will keep your Backburner free from grease
splatter and debris that may hinder its performance.
WARNING: You must remove the Backburner cover before
lighting the Backburner.
FLAVOR FROM WOOD CHIPS OR CHARCOAL
Convenient Fire Magic Gourmet Grilling Chips* are sold in
several different popular wood types. These chips are pre-
moistened and sealed in cans, a sample of which is provided
with your barbecue. To use follow the instructions on the side
of the can. After use there is no mess to clean up, just discard
the can of ashes after there is no longer any wood smoke
aroma. More Fire Magic Gourmet Grilling Chips* may be
purchased through your local dealer.
You may also add wood chips, wood chunks or the natural
wood charcoal of your choice to the Flavor Grid. We recommend
placing wood outside the direct cooking zone or wrapping it in
perforated aluminum foil. Soaking wood before use will slow
burning and increase smoke flavor. Wood and charcoal ash
will remain in the Flavor Grid after use. The Grid can be easily
removed and cleaned when unit has fully cooled.
*Available from your nearest Fire Magic Dealer