Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12. ROUTINE MAINTENANCE
Periodically check to ensure that the "B-Vent" venting
system is clear and that a negative draft is present
when the unit is operating. On fireplace insert models
there is a draft inspection tube the opening is located
on the right hand side behind the hinged side. A
vacuum should be present at the opening.
Periodically check the pilot and burner flames (See
Fig.11)
CLEANING OF GLASS
Do not clean glass when hot
It will be necessary to clean the ceramic glass
periodically. During a cold start up condensation will
sometimes form on the glass, this is a normal
condition with all gas fireplaces and stoves. However,
sometimes this condensation can allow dust and lint
to cling to the glass surface. Also, sometimes initial
paint curing of the appliance can leave behind a slight
film on the glass. This is a temporary problem. It is
therefore recommended that the glass be cleaned
initially after about the first two weeks of use.
After that, depending upon the amount of use,
cleaning should be required no more than two or three
times per season.
To clean the door, use a mild glass cleaner and a soft
cloth. Abrasive cleaners will damage the glass
surface.
OPENING THE GLASS DOOR
Turn unit off and wait until the appliance has cooled
down.
1. Open the right hand hinged side flap which will
expose a door fastener. Using a 1/2" wrench, loosen
the fastener.
2. Due to the shape of the bay window door. You
must also open the left hand side flap before
attempting to open the door.
3. Ensure the door is properly fastened after cleaning
before attempting to re-light the appliance.
TO REPLACE DOOR AND GLASS ASSEMBLY
The glass in this appliance is an integral part of the
door assembly. If the glass is damaged or broken a
replacement door assembly including glass must
be fitted.
To Replace
• open door fully
• Lift door vertically so that hinge pins lift out
of hinge receivers.
• Return assembly to dealer.
The Door and glass assembly must be replaced as
a complete unit by your ENVIROGAS Dealer. No
substitute materials are allowed
.
FOR CLEANING THE INSIDE OF THE
FIREBOX
Remove the log carefully from the firebox. Gently
remove the embers and place on a piece of paper
towel.
Vacuum the firebox thoroughly. Carefully clean
off any dust on the logs and remove any lint from
the main burners and pilot burner.
After carefully replacing the log and embers in
their correct positions, and the door has been
resealed, re-light the pilot, following the
instructions on the attached label.
CLEARANCES MUST BE SUFFICIENT TO ALLOW
ACCESS FOR MAINTENANCE AND SERVICE
LUBRICATING THE BLOWER
Every 6 months the blower should be lubricated if
installed
1. Turn the unit off and remove the log set.
2. Remove the burner tray assembly by removing
the screw on either side of the tray, between the
front and rear burners. Lift tray out.
3. Remove the 8 screws that hold the blower
mounting plate to the back firewall.
4. Carefully pull the blower assembly into the
firebox, exposing the blower lubricating holes (
located on the top of the motor housing on either
side of the label). Add 2 drops of SAE 20 oil.
5. If removal of the blower is necessary,
disconnect the blower leads from the harness.
Remove the blower.
6. To re-install, check mounting plate gasket and
reverse steps 1 through 4.
15