Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11. OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A) This appliance is equipped with a pilot which must be lit
by hand by following these instructions exactly.
B) BEFORE LIGHTING smell all around the appliance area for
gas, and next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. follow the gas suppliers instructions.
• If you cannot reach your gas supplier, call the fire
department.
C) Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, do not try to repair it . Call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
D) Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Turn off all electrical power to the appliance.
3. Turn the gas control knob clockwise to the
“off’ position.
4. Open door. Wait five (5) minutes to clear out any gas.
Close door. If you smell gas including near the floor,
STOP! Follow “B” in the above safety information.
If you don’t smell gas go to next step.
5. Find the pilot located to the right between the front and
rear burner.
6. Turn gas control knob counter-clockwise to
“PILOT”.
7. Push the gas control knob in fully and hold. Immediately
light the pilot by pushing the piezo spark ignitor. Keep
knob Depressed for about 30 seconds after pilot is lit.
Release knob. If pilot goes out, repeat steps 4 through 6.
WARNING The gas valve has an lockout device which will
not allow the pilot burner to be re-lit until the
thermocouple has cooled.
• If the knob does not pop up when released, stop and
Immediately call your service technician or gas
supplier.
• If the pilot will not stay lit after several tries, turn the
gas control knob to “OFF” and call your service
technician or gas supplier.
•
8. EUROSIT VALVE:
Turn gas control knob counter-clockwise to
the “LO” position. Then turn knob to the desired
setting.
9. NOVASIT VALVE:
Turn gas control knob counter-clockwise to
the “ON” position. Flip burner switch to “ON” then
turn “HI / LO” knob to the desired setting.
10.Turn on all electrical power to the unit
NOTE: Check to be sure the pilot flame engulfs the thermocouple and that the burners light completely.
TO TURN OFF GAS TO APPLIANCE
1. Turn the gas control knob clockwise to “OFF” DO NOT FORCE
2. Turn off all electrical power to the appliance if service is to be performed.
3. NOVASIT VALVE: Flip burner switch to off.
14