Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7. INSTALLATION OF LOGS, EMBERS and BRICK PANELS
INSTALLING THE GLOWING EMBERS and LOGSET
A bag of ceramic fiber embers is provided for use on the
burner PAN.
CAUTION: Use only the type of ember material supplied
with this appliance. Due to the irregular size of the ember
material there may be more than required. Use only a
single layer. Do not pile embers. The use of other foreign
materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers
require replacement, contact your nearest ENVIROGAS
dealer for replacement embers.
1. Carefully remove log from unit. Check to ensure there
is no damage. It is very important to install this log in
its proper position to insure safe, optimum operating
conditions.
2. Place the log set into the firebox with the burnt area
forward. Locate the log by seating it down onto the
burner tray supports already installed.
3. Gently remove the ember material from the plastic
bag. Place a single line of embers on burner as
shown beside.
4. Carefully avoid any clumping or large build ups. Do
not pack down, leave embers loose
5. Upon the first light up, watch for ignition to all burner
ports. If a long delay is noted:
First, wait for the appliance to cool down
• Open the front door of the appliance.
• Check to carefully reposition the embers making
sure that burner ports are not plugged solid or
blocked
REMOVING AND INSTALLING THE BRICK PANELS
Open the door. Remove the log set.
Optional ceramic panels
: Remove burners. Gently pull
right brick side panel inwards from the bottom back. Pull
towards the back then out freeing it from the front retainer.
Caution pilot may damage panel. Remove the left side
panel the same way. Remove the back panel from ledge.
To install, place back panel on ledge. Insert front edge of
brick panel into the retainer and very gently move panel
forward and out until flush against firebox side. Repeat for
other side.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH
THE DOOR REMOVED
Place ember material in the shaded area
only. Do not pack ember material down.
10