Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
110112-01C
19
INSTALLING HOOD
Install hood to top of firebox as shown in Figure
30. Use 3 Phillips screws provided.
INSTALLATION
Continued
Figure 30 - Installing Hood to Firebox
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no yellow flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log.
If so, reposition logs according to
the log installation instructions in
this manual. Yellow flames con
-
tacting logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs sup-
plied with heater. Before installing logs, make sure
log alignment screws are in place and straight.
1. Place log #1 (ember bed) onto base over log
alignment screws to the left of front burner and
behind middle burner. Log #1 will sit on top
of front and middle burners (see Figure 31).
2. Place log #2 to right of log #1 and onto log
alignment screw as shown in Figure 32. Log
#2 will wrap around right end of rear burner.
3. Place log #3 on left side of base and onto
alignment screw to right of rear burner (see
Figure 32). Log #3 will wrap around left end
of rear burner.
4. Place log #4 onto two alignment screws to rear
of base (see Figure 33).
Figure 31 - Installing Log #1 (Ember Bed)
Figure 32 - Installing Log #2 (Right) and
Log #3 (Left)
Log #2
Log #3
Log #1
Figure 33 - Installing Log #4
Log #2
Log #3
Log #1
Log #4