Desa (V)K36N Outdoor Fireplace User Manual


  Open as PDF
of 36
 
www.desatech.com
111923-01D 19
Figure 39 - Installing Alkaline Battery in Hand-Held Remote
Control Unit


1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to a 9-volt alkaline battery (not included).
Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
FIREPLACE INSTALLATION
Continued

-

securely in place. For replacement part information see
Replacement Parts, page 28.


glass is hot. Keep children and pets away from glass.


door or louvers.
Removing Louver Panels
Remove the top and bottom louver panels by simultaneously pulling
both top end spring latches towards the center of the appliance until
they are disengaged from the locating holes (see Figure 40). Repeat
for bottom spring latches and pull the louvers outward. To install or
replace items removed, simply reverse the procedures above.
Figure 40 - Removing Louver Panel
Louver Panel
Spring Latch
Removing Glass Door
If replacement of glass is necessary, the entire assembly, glass and
frame, must be replaced. If glass is broken, wear gloves and tape
the remaining fragments onto the frame.
1. Remove screen assembly by pushing the rod either left or right
and then down and forward to remove screen/rod assembly
from the rebox. Set assembly aside.
2. Lift up on latches to unlock. There are two on top of rebox and
two below rebox that hold glass door in place (see Figure 41).
3. While holding glass door to prevent it from falling and causing
injury, remove the ve screws from the hinge located on the
left side of door frame assembly (see Figure 41).
4. Remount the new frame at the hinge with ve new screws
before closing door. This will ensure seating of the gasket.
5.
Close glass door frame. Lock latches by placing the bar under the
tab on door and pushing down and back on latch (see Figure 41).
6. Replace screen/rod assembly by reversing step 1.
7. Replace louvers by reversing procedure under Removing Lou-
ver Panels.
Lock
Unlock
Glass
Frame
Assembly
Screw
Figure 41 - Removing/Replacing Glass Door
Hinge
Latch

See Cleaning and Maintenance on page 24.

BL36DA(SA) AND BL36DHA(SA)


You may purchase brick liner from your local retailer or see Ac-
cessories, page 29.
      


1. Remove top and bottom louvers to allow access to door
latches.
2. Unlock door latches and open glass door. See steps 1 and 2 of
Removing/Replacing Glass Door.
Battery Cover
Remote Control Unit
Terminal
Wires
9-Volt
Battery
Battery
Housing
 previous next