Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
111285-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
4
UNPACKING
CAUTION: Do not remove the warning and instruction
labels attached to the heater base assembly. These mark-
ings contain important warranty and safety information.
1. With utility knife, cut the carton all the way around above the
staples on the bottom tray. Lift the carton off the heater. Remove
packing.
Note:
The hood is located in the packing on the right
hand side of the heater front. Lift the heater off the bottom tray.
2. Locate two screws above top corners of the fireplace insert
screen. Remove and discard these screws. Lift fireplace insert
screen up and pull out to remove.
3. Remove protective packaging applied to logs, log base assem-
bly, and fireplace insert.
4. Remove fireplace insert hood from carton insert.
5. Check all items for any shipping damage. If damaged, promptly
inform dealer where you bought fireplace insert.
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that can be purchased
separately for this fireplace insert:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, page 30.
PRODUCT FEATURES
OPERATION
This vent-free fireplace insert is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a chimney. Heat is
generated by both realistic flames and glowing embers. When used
without the blower, the fireplace insert requires no electricity
making it ideal for emergency backup heat.
SAFETY DEVICE
This fireplace insert has a pilot with an Oxygen Depletion Sensing
(ODS) safety shutoff system. The ODS/pilot is a required feature for
vent-free room heaters. The ODS system shuts off the fireplace
insert if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace insert has a piezo ignitor. This system requires no
matches, batteries, or other sources to light fireplace insert.
BLOWER ASSEMBLY
This fireplace insert is equipped with a blower assembly. The blower
operates thermostatically and has a variable control. The blower circulates
heated air from the fireplace insert into the room. Use of blower is optional.
PRODUCT IDENTIFICATION
UNPACKING
REMOTE CONTROL ACCESSORIES
PRODUCT FEATURES
PRODUCT IDENTIFICATION
Figure 1 - Log Base Assembly
Figure 2 - Fireplace Insert
Top Louver
Assembly
Firebox
Hood
Bottom Louver
Assembly
Screen
Assembly
Top Outer
Casing
Firebox
Support
Blower
Assembly
Gas
Line
Access
O
F
F
P
I
L
O
T
O
N
H
I
L
O
One Piece
Log Set
Remote Selector
Switch (Optional)
Piezo
Ignitor
Optional
Remote
Control
Control Knobs