Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
111285-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
14
WARNING: You must operate this fireplace in-
sert with the fireplace insert screen in place. Make
sure fireplace insert screen is in place before run-
ning fireplace insert.
Figure 24 - Installing One Piece Log Set (Top View)
Figure 25 - Installing Fireplace Insert Screen
Notches
Screws for
Mounting
Screen
One Piece
Log Set
Burner
Ports
Figure 23 - Installing One Piece Log Set
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Chassis
"U"-shaped
Cutout in
Chassis
One Piece
Log Set
Burner
Middle Section
at Bottom of
Log Set
INSTALLATION
Continued
Figure 22 - Attaching Trim to Fireplace Surround
#6 Screws (4)
Trim
Fireplace
Surround
8. Line up holes in surround trim with holes on side panels of
fireplace surround assembly. Attach with screws provided (see
Figure 22).
9. Move heater and surround assembly to fireplace opening. Make
sure heater and surround assembly fit properly.
INSTALLATION
Assembling And Attaching Trim (Cont.)
Installing Logs
WARNING: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
1. Place one-piece log set on grate to fit as illustrated in Fig-
ure 23. Make sure middle section at bottom of log set is
seated into "U"-shaped cutout in center of chassis (see Fig-
ure 24).
IMPORTANT:
Make sure log does not cover any burner ports.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
INSTALLING LOGS
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty and
safety information.
2. Install fireplace insert screen by slipping notches of fireplace in-
sert screen over screws on front of fireplace insert (see Figure 25).