Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
108795-01M
For more information, visit www.desatech.com
17
17
Thermopile
Pilot Burner
Ignitor
INSPECTING BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper flame height.
Alterations may have occurred during shipping and handling. The
pilot is located on the back right hand side of the burner.
The height of the thermopile must be 3/8" to 1/2" above the pilot
flame. The flame from the pilot burner must extend beyond the
thermopile.
If your pilot assembly does not meet these requirements:
• Turn the adjustment screw marked pilot clockwise to decrease or
counterclockwise to increase the flame to proper size (see Figure
39, page 16). Do not remove the adjustment screw.
• see Troubleshooting, page 19
Figure 42 - Correct Pilot Flame Pattern
Figure 43 - Typical Flame Pattern
OPERATING FIREPLACE
Continued
Figure 41 - On/Off Hand-Held Remote Control Unit GHRCB
Control Button
Turns Burners
On and Off
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: The receiver and hand-held remote control kit must be
purchased separately (see Accessories, page 27). Follow instal-
lation instructions on page 10 of this manual.
1. After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position. Slide the selector switch
to the REMOTE position. Note: The burner may light if
hand-held remote was on when selector switch was last
turned off. You can now turn the burner on and off with
the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch in the RE-
MOTE or ON position when the pilot is not lit. This will
drain the battery.
2. Press the control button on the hand-held remote to turn
the burner on. Press the control button again to turn burner
off (see Figure 41).
3. To Lock press both buttons on remote control until light
stops flashing. Remote is now locked. If the fire is on it will
be turned off automatically. In the locked state, the light
will not light up when any button is pressed.
4. To Unlock press both buttons together on remote control
until light stops flashing. The remote is now unlocked.
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flames should
go up through the middle of logset. Flames should not "spill" to the
edges of the pan or sides of the logset.
Figure 43 shows a typical flame pattern. If burner flame pattern
differs from that described:
• turn appliance off (see To Turn Off Gas to Appliance,
page 16)
• see Troubleshooting
, page 19