Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
108795-01M
For more information, visit www.desatech.com
12
EMBER AND PAN MATERIAL PLACEMENT
1. Open the bag(s) of vermiculite and fill the entire burner pan
until the burner tube is completely covered (see Figure 22).
2. Smooth the pan material just even with edges of the burner
pan.
3. Remove the ember material from the bag and flatten small
amounts into quarter size pieces and lay on top of the surface
of the pan material (see Figure 23).
4. Place just enough to cover the entire surface and leave about
a 1/2 inch gap under the lower grate members to allow air to
flow (see Figure 24).
INSTALLATION
Continued
Figure 22 - Fill Entire Burner Pan with Vermiculite
Figure 23 - Ember Material on Surface of Pan Material
(Vermiculite)
0.5"
0.5"
Figure 24 - Pan and Ember Material Clearances
Vermiculite
(Pan Material)
Burner Pan
Grate
Ember
Material
Burner Pan
Vermiculite
(Pan Material)
Grate
Grate
Burner Pan
Pan and Ember
Material
LOG PLACEMENT FOR M36, M36P, VM36 AND
VM36P MODELS
1. Place small front right log (log 1) on right front of grate as
shown in Figure 25.
2. Place large back log (log 2) onto grate making sure notches
rest over grate as shown in Figure 25.
3. Place log 3 into notch on log 2, resting the front end on top of
log 1 (see Figure 26).
4. Place the upper end of log 4 into the notch on log 2 as shown
in Figure 26. Rest the lower end of log 4 onto the middle grate
finger as shown in Figure 27.
Figure 25 - Installing Logs 1 and 2
Figure 26 - Installing Logs 3 and 4
Log 1
Log 2
Log 3
Log 4
Log 2
Log 1
Notch
Notches