Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
6
STEP 6: (S
EE FIGURE
6
)
• Assemble an axle clip (S) and a wheel with the valve
stem facing out onto the axle. Assemble a hub cap
(P) by pressing or tapping it onto the axle. Repeat on
other end of axle.
FIGURE 8
STEP 8: (S
EE FIGURE
8
)
• Insert two 1/4" x 1-3/4" hex bolts (D) through the
handle tube as shown in fi gure 8. Holding the bolts in
place in the handle, insert the bolts through the holes
in the poly tray, allowing the legs of the handle to slip
beneath the latch stand bracket. Secure the two bolts
with two 1/4" fl at washers (I) and 1/4" nylock nuts (J).
Do not tighten yet.
FIGURE 7
FIGURE 6
STEP 7: (S
EE FIGURE
7
)
• Attach two noise reduction pads (R) to the bottom of
the latch stand bracket.
• Turn the assembled tongue, wheel support and
wheels over to the upright position. Place the latch
stand bracket onto the tongue between the latch lock
assembly and the raised tab. Place the poly tray onto
the wheel support and latch stand bracket. Fasten
the tray to the wheel support using eight 5/16" x 3/4"
truss head bolts (F) and 5/16" nylock nuts (K).
Do not
tighten yet.
• Place the latch stand plate between the latch stand
bracket and the poly tray.
(P) HUB CAP
WHEEL
AXLE
(S) AXLE CLIP
(K) 5/16"
NYLOCK NUTS
(F) 5/16" x 3/4"
TRUSS HEAD
BOLT
LATCH STAND
BRACKET
LATCH
STAND
PLATE
PADS (R)
(D) 1/4" x 1-3/4"
HEX BOLT
(I) 1/4" FLAT
WASHER
(J) 1/4" NYLOCK
NUT
LATCH STAND
BRACKET