Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
1. Align the tabs on the Side
Tables with the slots on the
side of the grill (Fig. 37).
Fig. 37
2. Use firm pressure to push the
Side Tables down and into
place (Fig. 38). The joint
between the Side Tables
and the Grill will be even.
Fig. 38
Grill Assembly (continued)
11
Fig. 39
3. Engage the locks by firmly pushing the tabs into the slots (Fig. 39). Be
sure to engage two locks on each side table.
WARNING
This procedure MUST be performed OUTDOORS only! Be sure the
L.P. cylinder valve is closed. Attach to the grill. Read and follow the
directions on the cylinder.
20# LP Cylinder Installation
NOTE: Your 9998 Series grill is set up from the factory
to use a 20# refillable LP cylinder. You may
purchase a 20# LP cylinder from the store
where you bought your grill, or from your local
propane dealer.
1. Set the LP Cylinder in the Cylinder Support location with the outlet
valve facing toward the door opening of the grill. Lower the Tank
Support to engage the Cylinder Collar (Fig. 40).
Fig. 40
20# LP Cylinder Installation (continued)
CAUTION
In the connection process, the grill side of the connection will
seal on the back-check in the valve, resulting in a slight
resistance. The connection requires about one-half to three-
quarters additional turn to complete the connection.
To disconnect, turn counterclockwise.
Tighten by hand only. DO NOT use tools.
IMPORTANT!
TO ENSURE PROPER GAS FLOW, BURNER
CONTROL VALVES MUST
BE “OFF” BEFORE OPENING
THE GAS CYLINDER VALVE
.
WARNING: During assembly of
the grill and when attaching or
replacing the L.P. gas cylinder, insure
that the gas supply hose is free of
kinks and/or damage and is at least 3
inches away from hot surfaces such
as the grill casting.
Fig. 41
3. Check that the cylinder valve
is closed by turning the
cylinder knob clockwise to a
full stop (Fig. 41).
Assemble the Side Tables