Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Installation / Assembly
5
2009 Fireplaces and Firepits
LTR20091006, Rev. B
www.calspas.com
Installation must conform with local building and/or re codes, or in
the absence of local codes:
National Fuel Gas Code ANSI Z223.1 / INFPA 54 (for installation in •
the United States)
CSA B149.1 Natural Gas and CAN/CGA-BIL/9-2, Propane Installa-•
tion code (for installation in Canada).
Location
Place your repit or replace on a at and stable surface in an outdoor
location such as a patio deck. Do not locate the appliance where it can
get excessively wet or submerged in water.
When determining a suitable location, take into account concerns such
as exposure to wind, proximity to trafc paths, and windows that open
into the home.
Locate your repit or replace adjacent to the gas supply line (LP or
NG), preferably with the shortest gas line run possible.
Maintain the following clearances to combustible materials on all Cal
Flame replaces and re pits. Measure from the outside of the unit.
Sides (all around) 48 inches (1.2 m)
Top 72 inches (1.8 m)
Installation
Installation and service must be performed by a quali-
ed installer, service agency or your natural gas or liquid
propane (LP) gas provider.
Your Cal Flame repit or replace is designed and in-
tended for OUTDOOR USE ONLY in a well ventilated space
and must not be used inside a building, garage, or any other
enclosed area.