Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
2
Safety Instructions
2009 Fireplaces and Firepits
LTR20091006, Rev. B
www.calspas.com
Do not block the vents located near the base of your repit or •
replace as gas may build up in case of leak and cause serious
damage.
Do not install or operate your replace in such a manner that the •
cross ventilation openings are blocked. Fresh air must be able to
pass though installed vents to safeguard against residual gas ac-
cumulation. Failure to allow proper ventilation may cause re or
explosion.
Do not locate appliance where it can get excessively wet. Do not •
use this appliance if any part has been underwater. Immediately
call a qualied service technician to inspect the unit and to replace
any part of the control system and any gas control which has been
underwater.
Set-Up
You are responsible for ensuring that a natural gas line (if required) •
is installed and safe for use. We recommend that a licensed con-
tractor install your replace or repit. Installation must conform to
local codes, or in the absence of local codes, with either the Na-
tional Fuel Gas Code, ANSI Z223.1 / NFPA54, Natural Gas and
Propane Installation Code, CSA B149.1, or Propane Storage
and Handling Code, B149.2), as applicable.
Do not use an extension cord to supply power to your replace or •
repit. Such use may result in re, electrical shock or other per-
sonal injury. Do not install a fuse in the neutral or ground circuit.
A fuse in the neutral or ground circuit may result in an electrical
shock hazard. Do not ground this appliance to a gas supply pipe or
hot water pipe. Keep any electrical supply cords and the fuel supply
hose away from any heated surfaces.
To prevent re and smoke damage, remove all packaging material •
before operating the replace or repit.
Operation
Do not use charcoal or other solid fuel in gas burning re-•
places and re pits.
Do not use your repit or replace for cooking.•
In the event that a burner goes out, turn burner knobs to the full •
OFF position and let it air out. Do not attempt to use the repit or
replace until the gas has had time to dissipate.