Cal Flame LTR20091006 Outdoor Fireplace User Manual


 
20
Using Your Grill
2009 Fireplaces and Firepits
LTR20091006, Rev. B
www.calspas.com
Do not use this appliance if any part has been under water. Imme-
diately call a qualied service technician to inspect the appliance
and replace any part of the control system and any gas control
which has been under water.
Make sure the ignitor battery has been installed properly. Ignitor
will not operate properly without a battery installed.
Lighting Instructions for Automatic
Starter
Remove protective storage cover and locate the manual gas con-1.
trol valve and igniter button on the replace.
Make sure fuel supply is properly connected and turned on at the 2.
source.
Depress igniter button until you hear it sparking. You will hear a 3.
small popping noise. Keep igniter button pushed in while slowly
turning the fuel ow valve to the full ow position at the replace.
The replace should light within 5 seconds. If you do not hear the
igniter sparking you may need to replace the battery. The starter
uses one standard AAA battery, located directly behind the rubber
push button knob. (Unscrew knob to access battery.) Note some
models ship with the batteries removed or may not be included
with your model.
If a ame does not start within 10 seconds, shut off all gas supply 4.
and wait ve minutes to allow all gas fumes to clear. Re-try or go
to trouble-shooting and start again from step 1.