Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
9
GENERAL CUTTING (Fig. 6)
Hold your saw firmly in front of and clearly
away from you. Make sure saw blade is clear of
any foreign material. Be sure material to be cut
is held firmly. Small work pieces should be
securely clamped in a vise or with clamps to the
work bench or table. Mark the line of cut clearly.
Depress the lock-off button, then pull switch
trigger to start the cutting action.
Place the base assembly against the work piece.
Then move the blade into the work piece. Do not
force. Use only enough pressure to keep the
saw cutting. Let the blade and saw do the work.
Use of excessive pressure that causes bending
or twisting of the blade may result in broken
blades.
PLUNGE CUTTING (Fig. 7)
Mark the line of cut clearly. Choose a convenient
starting point inside the area to be cut out and
place the tip of the blade over that point. Rest
front edge of base (shoe) on work and hold
firmly in position. Depress the lock-off button,
then pull switch trigger to start the cutting action.
WARNING:
Make sure blade does not touch work until motor
reaches full speed, since this could cause loss
of control resulting in serious injury. With saw
blade at full cutting speed, slowly tilt saw
down-ward until tip of blade starts cutting work.
After blade penetrates work, tilt saw until blade
is perpendicular to the work.