Agri-Fab 45-01773 Outdoor Cart User Manual


  Open as PDF
of 12
 
5
16. Turn the cart upside down. Place the handle tube on
thebottomofthecartasshowningure10. Placethe
four tube clamps over the handle tube, with the longer
leg of each tube clamp to the outside. Secure the four
tube clamps over the handle tube using eight M6X25
screws,eightatwashersandeighthexnuts.Makeonly
ngertightuntilalleightscrewsareinplaceandthen
tighten securely.Seegure10.
FIGURE 11
FIGURE 10
17. Insert a M6X25 screw through the hole at the rear of
each side panel and the hole at the rear of each side
angle.SecurewithM6atwashersandM6hexnuts,
makingonlyngertightatthistime.Seegure11.
18. Place the tube caps on the ends of the “W” shaped leg
tube.Seegure11.
19. With the cart still upside down, assemble the leg tube
to the bottom of the cart. Line up the two holes in the
center of the leg tube with the holes in the bottom of
the cart. Secure the leg tube to the bottom of the cart
withtwoM6X50screws,M6atwashersandM6hex
nuts.Makeonlyngertightatthistime.Seegure11.
20. Attach the leg tube to the side panels with four M6 x50
screws,M6atwashersandM6hexnuts.Makeonly
ngertightatthistime.Seegure11.
21. Fasten the support straps to the leg tube with two M6X40
screws,M6atwashersandM6hexnuts.Seegure
11.
22. At this time tighten securely all screws and nuts
ENGLISH
The length of the handle tube can be
adjusted by sliding the tube in or out
before tightening the four clamps. see
gure 10.
NOTE
HANDLE
TUBLE
M6 HEX
NUT AND
Ф
6 FLAT
WASHER
TUBE CLAMP
BOTTOM
PANEL
SIDE
PANEL
M6X25 SCREW
M6 HEX
NUT AND
Ф
6 FLAT
WASHER
LEG
TUBE
HANDLE
TUBE
M6 HEX
NUT AND
Ф
6 FLAT
WASHER
M6X50
SCREW
M6X25
SCREW
M6X40
SCREW
SIDE PANEL
SUPPORT
STRAP
 previous next