Agri-Fab 45-01773 Outdoor Cart User Manual


  Open as PDF
of 12
 
4
9. Position a side panel againist a side angle, resting it
down on top of the front panel. Place a support strap on
the outside of the side angle and start a M6X30 screw
through the second hole in the side panel, the side
angleandthesupportstrap.Securewithaatwasher
and hex nut. Make only nger tight at this time. See
gure7.
10. Start a M6X30 screw through the top hole in the side
panel, the front angle assembly and the support strap.
Securewithaatwasherandhexnut.Make only nger
tight at this time.Seegure7.
11. Repeat steps 9 and 10 for the other side panel.
12. Start one M6X25 screw through the bottom hole in the
side panel and the front angle assembly. Start another
M6X25 screw through the front hole in the side panel
andthesideangle.Securewithtwoatwashersand
two hex nuts, making only nger tight at this time.
Seegure8.
13. Repeat step 12 for the other side panel.
14. Tighten all nuts and screws securely at this time, except
fornutsandscrewsinaxleclamps.Seegure8.
FIGURE 8
FIGURE 7
ENGLISH
M6
HEX
NUT
Ф
6
FLAT
WASHER
M6X30
SCREW
SIDE
PANEL
TOP
HOLE
SECOND
HOLE
M6X30
SCREW
FRONT
ANGLE
ASS'Y
SUPPORT
STRAP
FRONT
PANEL
M6
HEX
NUT
Ф
6
FLAT
WASHER
M6X25
SCREW
SIDE
PANEL
FRONT
HOLE
FRONT
ANGLE
ASS'Y
FRONT
PANEL
BOTTOM
HOLE
FIGURE 9
15. Laythecartdownontheoorsothatthesidesareup
in a normal position. Remove the front panel by sliding
it up, then remove the four large washers you used for
shims.Seegure9.
SIDE
PANEL
CART
(4) LARGE
FLAT
WASHERS
USED AS
SHIMS
FRONT
PANEL
SIDE
PANEL
 previous next