Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
3-2 Red Hat Linux 3.0 and 4.0 Driver Installation
Copyright © 2006 by LSI Logic Corporation. All rights reserved.
3.2 Adding the Red Hat Linux Driver to an Existing
Installation
Perform the following procedure to add the Red Hat Linux 4.0 driver to
an existing installation:
Step 1. Power-up the system.
The system will initialize hardware.
Step 2. The system detects the controller and invokes Kudzu, the
Red Hat Linux hardware configuration utility. The following
RAID controller is added to your system:
LSI Logic / Symbios Logic MegaSAS
You can select one of the following options:
• Configure the device.
• Ignore the device. No configuration will be added, but you
will not be prompted if the device is detected on
subsequent reboots.
• Do nothing. No configuration will be added, and the device
will show up as new if it is detected on subsequent reboots.
Step 3. Highlight the Configure tab, and press ENTER.
The system configures the controller and installs the
appropriate driver in the kernel.
Step 4. The system boots and displays the devices connected or
configured on the controller.