Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
MegaRAID SAS Device Driver Installation User’s Guide 3-1
Copyright © 2006 by LSI Logic Corporation. All rights reserved.
Chapter 3
Red Hat Linux 3.0 and
4.0 Driver Installation
This chapter describes the installation of the device driver in new
Red Hat Linux 3.0 and 4.0 systems and the update to the Red Hat Linux
driver on an existing Red Hat Linux system. It consists of the following
sections:
• Section 3.1, “Installing the Driver in a New Red Hat Linux System”
• Section 3.2, “Adding the Red Hat Linux Driver to an Existing
Installation”
• Section 3.3, “Updating the Red Hat Linux System Driver”
Refer to the release notes that accompanied the driver for information on
an existing Red Hat Linux system.
3.1 Installing the Driver in a New Red Hat Linux System
Perform the following steps to install the MegaSAS device driver in a new
Red Hat Linux system:
Step 1. Create a driver diskette using the Linux driver image from the
Universal Driver Suite CD.
Step 2. Boot to CD-ROM with Disk 1.
Step 3. Type:
linux dd
Step 4. Insert the driver diskette.
The utility locates and loads the driver for your device.
Step 5. Press ALT+CTRL+F4 to verify the driver is loaded.
Step 6. Follow the Red Hat Linux installation procedure to complete the
installation.