Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
22
Check the following connections, as shown in figure 11:
a) Test valve to regulator connection.
b) Quick disconnect fitting to LP tank connection.
If bubbles occur, or if a bubble enlarges, the connection
is leaking, turn OFF the gas at LP tank.
If the leak is at connection a) DO NOT OPERATE THE
BARBECUE. Contact your dealer.
If the leak is at connection b), disconnect and reconnect
the quick disconnect fitting. Turn the gas back on and
recheck with the soap and water solution.
WARNING: If leak persists after tightening the
connection, turn OFF the gas at LP tank. DO NOT
OPERATE THE BARBECUE. Contact your dealer.
After completing the leak checks:
a) Turn the LP tank valve OFF (clockwise) and rinse
connections with water.
b) Turn the test valve to the OPEN position (parallel to
the hose). Figure 11.
LP Tank
The LP tank manufacturer is responsible for the materials,
workmanship and performance of the tank. If the tank has a
defect, malfunctions, or you have a question regarding the
tank, call the tank manufacturer's customer service center.
The phone number is on the warning decal which is
permanently attached to the tank. If the tank manufacturer
has not resolved the issue to your satisfaction, then call
Weber-Stephen Products Co., Customer Service Center.
Connecting the LP tank
WARNING: Make sure LP tank valve is closed.
Close by turning clockwise.
You will need: filled LP tank, a soap and water solution
and a rag or brush to apply it.
Lift LP tank onto tank holder.
Slide back the collar of the quick disconnect on the tank
valve. Figure 10 (a). Push the male fitting of the
regulator into the quick disconnect, and maintain
pressure. Slide the collar closed. Figure 10 (b). If it does
not engage or lock, repeat procedure. Gas will not flow
unless the quick disconnect is properly engaged.
Mix soap and water.
Open the tank valve.
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - Since some leak test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
To perform leak checks: Turn test valve to the CLOSED
position. Figure 11. Turn tank valve ON
(counterclockwise). Check for leaks by wetting the
connections with the soap and water solution and
watching for bubbles.
Figure 10
(a)
(b)
DANGER
Do not use an open flame to check for
gas leaks. Be sure there are no sparks or
open flames in the area while you check
for leaks. This will result in a fire or
explosion which can cause serious bodily
injury or death and damage to property.
Figure 11
Test valve in CLOSED position Test valve in OPEN position
(b)
(a)
Male fitting
Quick disconnect
engaged
Quick disconnect
retracted
Collar
Regulator