Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
11
Figure 4
Step 4
Continue frame assembly
You will need: frame assembly, front panel, four 1/2
inch bolts, four nylon washers and a 7/16 inch open-end
or an adjustable wrench.
Place front panel along inside edge of frame assembly
with Weber logo on the side closest to the wheel
frame and facing out. Slip washers on bolts, insert
bolts through the front panel and screw into the frame
assembly. Figure 4.
Add the remaining bolts and washers to the other side
of the frame and tighten. Figure 4.
Figure 5
Step 5
Complete frame assembly
You will need: two bottom connectors, tank holder
assembly, four 1 3/4 inch bolts, four nylon washers and
a 7/16 inch open-end or an adjustable wrench.
Turn over partial frame assembly and remove twist tie
from CharBin lid.
Hold one bottom connector between wheel and caster
frames, below front panel. Place washer on bolt, insert
through wheel frame and screw into bottom connector.
Figure 5.
Lift open CharBin lid. Insert tank holder assembly tabs
into the slots in the frame brace. Figure 5 (a). Slide up
until the notch at the bottom of the tank holder assembly
fits over the cross brace of the caster frame.
Figure 5 (b).
Place washer on bolt, insert through tank holder
assembly and frame, and screw into bottom connector.
Do not fully tighten bolts until both bottom
connectors are in place.
Hold the other bottom connector between wheel and
caster frames. Add washers to bolts. Insert bolts
through frame and screw into bottom connector.
Figure 5. Tighten all four bolts.
(a)
Slots in frame brace
CharBin lid
Install this
bolt first
Bottom connector
Weber nameplate facing out
(b)