Weber Genesis Silver B Gas Grill Gas Grill User Manual


  Open as PDF
of 35
 
2828
1
2
7
5
4
6
Figure 1
Crossover Ignition System
OPERATING INSTRUCTIONS
Lighting
Summary lighting instructions are on the control panel.
1) Open the lid. Figure 1.
2) Make sure all burner control knobs are turned OFF.
(Push each burner control knob down and turn
clockwise.)
3) Turn gas supply valve on.
ƽWARNING: Do not lean over open barbecue.
Keep your face and body at least one foot away
from the matchlight hole when lighting the
barbecue.
4) Push Front burner control knob down and turn to
START/ HI.
5) Push the Crossover Ignition Button several times,
so it clicks each time.
6) Check that the burner is lit by looking through the
matchlight hole on the front of the cooking box.
ƽWARNING: If the burner does not light, turn the
Front burner control knob to OFF and wait 5
minutes to let the gas clear before you try again or
try to light with a match.
7) After the FRONT burner is lit you can turn on the
other burners.
Note - Always light the FRONT burner first. The other
burners ignite from the FRONT burner.
To Extinguish
Turn gas supply OFF at the source, then push
down and turn each burner control knob
clockwise to OFF.
ƽ DANGER
Failure to open lid while igniting the
barbecue, or not waiting 5 minutes to
allow the gas to clear if the barbecue
does not light, may result in an
explosive flame-up which can cause
serious bodily injury or death.
Crossover Ignition System
Note - The Crossover Ignition System ignites the Front
burner with a spark from the igniter electrode inside the
Gas Catcher Ignition Chamber. You generate the
energy for the spark by pushing the Crossover Ignition
Button until it clicks.
ƽWARNING: Check gas supply line before each
use of barbecue for nicks or cracking. If the gas
supply line is found to be damaged in any way, do
not use the barbecue. Replace using only Weber
authorized replacement gas supply line. Order
from Weber-Stephen Products Co., Customer
Service Center.
 previous next