Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
19
Guide screw
(a)
(b)
Wing nuts
View from
behind
cooking
box
Figure 13
Figure 11
Burner tubes
Frame brace
Slide the cooking box to the left within the frame. Put
nylon washer on bolt. Insert the bolt through the frame
and cooking box with the head of the bolt outside the
frame. Figure 12. Add the keps nut. Tighten by holding
the bolt with pliers while you tighten the nut with the
7/16 inch wrench.
Figure 12
Step 7
Add cooking box
You will need: frame assembly, cooking box assembly,
spacer bracket, 1/4-20 x 2 inch bolt, nylon washer,
1/4-20 keps nut, pliers and a 7/16 inch wrench.
Set the cooking box in the frame so the burner tubes
are under the frame brace. Figure 11.
Note: Be careful when sliding the burner tubes
through the side frame.
Your Weber Gas Barbecue burner assembly has been
factory assembled, pressure and flame tested. As a
safety precaution we recommend you check the burner
alignment:
a) Are the ends of the burners under the washers at
the left rear and left front of the cooking box? The
screws are only guides. Do not tighten. Figure 13 (a).
b) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers. Figure 13 (b).
If you answered YES to a and b, the burners are
correctly aligned. If you answered NO, the burners are
misaligned. Contact Weber-Stephen Customer
Service. Do not use barbecue.