Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
37
ƽWARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note: All factory made connections have been
thoroughly checked for gas leaks. The burners have
been flame tested. As a safety precaution you should
recheck all fittings for leaks before using your Weber
Gas Barbecue. Shipping and handling may have
loosened or damaged a gas fitting.
You will need: a soap and water solution and a rag or
brush to apply it.
To perform leak checks: Open cylinder valve by turning
the cylinder valve handwheel counterclockwise.
Figure 9
a)
c)
b)
d)
Manifold
Manifold
Annual Maintenance
After a period of nonuse we recommend that you
perform the following maintenance procedures for your
safety.
ƽWARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts. If
the hose is found to be damaged in any way, do not
use the barbecue. Replace using only Weber
authorized replacement manifold assembly. Contact
your dealer.
■ Check all gas fittings for leaks.
ƽ DANGER ƽ
Do not use an open flame to check for
gas leaks. Be sure there are no sparks or
open flames in the area while you check for
leaks. This will result in a fire or explosion
which can cause serious bodily injury or
death and damage to property.
Inspection and Cleaning of the Weber
Spider Stopper Guards
To inspect the Spider Stopper Guards, remove the
control panel and look to see if they have dust or dirt on
their outside surfaces. If they are dirty, brush off the
outside surface of the Spider Stopper Guards with a soft
bristle brush (an old toothbrush for example). Check that
there are no gaps in the Spider Stopper Guards’ seams
or in the fit around the burners or valves. (See Section
"General Maintenance".)