Weber FT 600 Gas Grill User Manual


 
31
Manual Lighting
EACH HEAT ZONE OPERATES INDEPENDENTLY.
1) Open the sliding work surfaces and splash guards.
Figure 2.
2) Check that fuel scale reads more than “E”.
Note - E = empty; F = full.
3) Make sure all burner control knobs are turned OFF.
(Push each burner control knob down and turn
clockwise.)
ƽWARNING: The burner control knobs must be in
the OFF position before turning on the LP tank
valve. If they are not in the OFF position, when you
turn on the LP tank valve, the excess flow control
will activate, limiting the flow of gas from the LP
tank. If this should occur, turn OFF the LP tank valve
and burner control knobs and start over.
4) Turn on gas supply.
5) Select heat zone.
6) Put a match in the match holder and strike the
match.
7) Push LEFT burner control knob down and turn to
H (high).
ƽWARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
8) Insert match holder and lit match through matchlight
hole to ignite LEFT burner.
ƽ DANGER ƽ
Failure to open sliding work surfaces
while igniting the barbecue, or not waiting 5
minutes to allow the gas to clear if the
barbecue does not light, may result in an
explosive flame-up which can cause serious
bodily injury or death.
Figure 2
Figure 3
Manual Lighting
High Medium Low Off
3
2
4
1
9) Observe if LEFT burner has ignited by looking
through matchlight hole.
ƽWARNING: If LEFT burner fails to ignite turn LEFT
burner control knob to OFF and wait 5 minutes
before attempting to ignite again.
10) After the LEFT burner is lit you can turn on the
RIGHT burner.
Note: Always light the LEFT burner first. The RIGHT
burner ignites from the LEFT burner.
To Extinguish
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
Control panel
matchlight hole
in control panel
Hole in cooking
box assembly
Left burner tube
ƽ DANGER ƽ
When the excess flow control is activated,
a small amount of gas is still flowing to the
burners. After turning OFF the tank and
burner control knobs, wait at least 5 minutes
for the gas to clear before attempting to light
the barbecue. Failure to do so may result in
an explosive flame-up which can cause
serious bodily injury or death.