Weber EP-310/320 Gas Grill User Manual


 
13
WWW.WEBER.COM
®
13
GAS INSTRUCTIONS
LIGHTING
Summary lighting instructions are inside the left hand cabinet door.
ƽ DANGER
Failure to open the lid while igniting the barbecue’s burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive ame-up,
which can cause serious bodily injury or death.
Crossover
®
Ignition System
Note - The Crossover
®
ignition system ignites BURNER 1 with a spark from the igniter
electrode inside the Gas Catcher
ignition chamber. You generate the energy for the
spark by pushing the electronic ignition button. You will hear it sparking.
ƽ WARNING: Check hose each time before using barbecue
for nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue. Replace
using only Weber
®
authorised replacement hose. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto
www.weber.com
®
.
A
B
C
b)
1.
a)
(1)
GAS INSTRUCTIONS
OPERATING INSTRUCTIONS
REFILLING THE LIQUID PROPANE CYLINDER
We recommend that you re ll the LP cylinder before it is completely empty.
To re ll, take LP cylinder to a “Gas Propane” dealer.
Removal of the gas supply cylinder
1) Shut off gas supply.
2) Disconnect hose with regulator from the cylinder.
A) Unscrew regulator tting from tank turning clockwise.
B) Move regulator lever (b) to down/off position. Push in regulator lever (b)
until it releases from tank.
C) Move regulator lever to off position. Slide collar of regulator up (1) to
disconnect from tank.
3) Exchange empty cylinder for a full cylinder.
MOUNTING THE CYLINDER
Hold the hanger and tilt the cylinder so the two bent supports of the hanger are located
underneath the cylinder base ange. Adjust the length of the belt to the cylinder and
snap ends together.
Lift and place the cylinder hanger on the cylinder bracket as shown. (1)
RECONNECTING THE LIQUID PROPANE CYLINDER
See “CONNECTING THE LIQUID PROPANE CYLINDER”.