Weber EP-310/320 Gas Grill User Manual


  Open as PDF
of 20
 
12
WWW.WEBER.COM
®
GAS INSTRUCTIONS
Check:
1) Hose-to-manifold connection.
2) Side burner hose-to-manifold connection and side burner hose-to-side burner gas
line connection.
3) Side burner hose-to-side burner connection, side burner valve and orifi ce
connections.
ƽ WARNING: If there is a leak at connection (1, 2, or 3),
retighten the fi tting with a spanner and recheck for leaks
with soap-and-water solution. If a leak persists after re-
tightening the fi tting, turn OFF the gas.
DO NOT OPERATE THE GRILL. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
®
.
4) Regulator-to-cylinder connection.
5) Hose-to-regulator connection.
6) Valves-to-manifold connections.
ƽ WARNING: If there is a leak at connections (4, 5 or 6), turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your area using the
contact information on our web site. Log onto
www.weber.com
®
.
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
(4)
(5)
(6)
(1)
(2)
(3)
320
GAS INSTRUCTIONS
SAFE HANDLING TIPS FOR LIQUID PROPANE GAS CYLINDERS
• Liquid Propane (LP) gas is a petroleum product as are petrol and natural gas. LP
gas is a gas at normal temperatures and pressures. Under moderate pressure,
inside a cylinder, LP gas is a liquid. As the pressure is released, the liquid readily
vapourises and becomes gas.
• LP gas has an odor similar to natural gas. You should be aware of this odor.
• LP gas is heavier than air. Leaking LP gas may collect in low areas and prevent
dispersion.
• The LP cylinder must be installed, transported and stored in an upright position.
LP cylinders should not be dropped or handled roughly.
• Never store or transport the LP cylinder where temperatures can reach 51°C (too
hot to hold by hand - for example: do not leave the LP cylinder in a car on a hot
day).
• Treat “empty” LP cylinders with the same care as when full. Even when the LP
tank is empty of liquid there still may be gas pressure in the cylinder. Always close
the cylinder valve before disconnecting.
• Do not use a damaged LP cylinder. Dented or rusty LP cylinders or LP cylinders
with a damaged valve may be hazardous and should be replaced with a new one
immediately.
LIQUID PROPANE (LP) CYLINDER(S)
• The joint where the hose connects to the LP cylinder must be leak tested each
time the LP cylinder is reconnected. For example, test each time the LP cylinder is
refi lled.
• Be sure the regulator is mounted with the small vent hole pointed downward so
that it will not collect water. This vent should be free of dirt, grease, insects etc.
*The grill illustrated may have
slight differences to the model
purchased.
 previous next