Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
25
Hair pin cotter
Hinge pin
Figure 28
Figure 29
Tool holders
Control panel
push-in buttons
(a)
(b)
Step 18
Install Lid
You will need: lid, two hinge pins and two hair pin
cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins. Figure
28.
Step 19
Add tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel, two
Phillips screws/washers, a Phillips screwdriver, and
three burner control knobs.
Hook the tool holders over the frame rail and snap
down into place. Figure 29.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Line up the holes in the control
panel with the holes in the inserts in the frame brace.
Insert screws and tighten with a Phillips screwdriver
until snug. Do not overtighten. Figure 29 (a).
Push on the burner control knobs. Figure 29 (b).
Crossover
Ignition Button
Insert in
frame brace