Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
14
TRoUbLESHooTING
PRobLEm cHEcK SoLUTIoN
Burner burns with a yellow or orange flame, in
conjunction with the smell of gas.
Inspect Weber
®
Spider/Insect screen for possible
obstructions. (Blockage of holes).
Clean Weber
®
Spider/Insect screen. Refer to “ANNUAL
MAINTENANCE”.
Burner does not light, or flame is low in HI position. Is propane cylinder fuel low or empty? Replace propane cylinder.
Refer to “GAS INSTRUCTIONS”.
Burner does not light when you push the igniter
button.
Be sure that there is gas flow to the burners by attempting
to match light your burners. Refer to “MANUAL IGNITION”.
If match lighting is successful, the problem lies in the
ignition system. Refer to “MAINTENANCE”.
Is there is a fresh battery installed? Verify that the battery is in good condition and installed
correctly. Refer to “BEFORE USING THE BARBECUE”.
Are the wires connected properly to the ignition box? Be sure that wires are correctly inserted into terminals on
ignition box. Refer to “MAINTENANCE”.
Is there plastic wrapping around the new battery? Remove plastic wrapping. Do not confuse this with the
battery label.
Is burner tube positioned too far away from the igniter
electrode?
Check that the burner tube is positioned correctly to the
igniter electrode. Refer to “MAINTENANCE”.
Experiencing flare-ups:
m CAUTION: Do not line the cookbox
with aluminum foil.
Are you preheating barbecue in the prescribed manner? All burners on HI for 10 to 15 minutes for preheating.
Is the cooking grate heavily coated with burned-on
grease?
Clean thoroughly. Refer to “CLEANING”.
Is the cookbox dirty and not allowing grease to flow into
catch pan?
Clean cookbox. Refer to “CLEANING”.
Burner flame pattern is erratic. Flame is low when
burner is on HI. Flames do not run the whole length
of the burner tube.
Are burners clean? Clean burner. Refer to “MAINTENANCE”.
Inside of lid appears to be “peeling.” (Resembles
paint peeling.)
The lid is cast aluminum, not paint. It cannot “peel”. What
you are seeing is baked on grease that has turned to
carbon and is flaking off.
THIS IS NOT A DEFECT.
Clean thoroughly. Refer to “CLEANING”.
If problems cannot be corrected using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.