Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
27
Bushing in frame
connector and
short hinge pin
Bushing in the
underside
Bushing in underside
and long hinge pin
(a)
(c)
(d)
(e)
(b)
Step 31
Install glass doors
You will need: one LH glass door assembly and two RH
glass door assemblies.
Start with the LH door assembly. Insert the long hinge pin
at the top of the door into the plastic bushing in the
underside of the left frame. Insert the bottom (short) hinge
pin into the bushing in the frame connector. Repeat the
procedure with the RH door assemblies. The glass doors
latch on the frame connector. Figure 44.
Step 32
Complete accessory installation
You will need: work table, Warm-Up Basket, warming rack,
thermometer, two tubing plugs and a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 45 (a).
Set the work table onto the left side rails. Figure 45 (b).
Set the warming rack into the slots at the rear of the
cooking box. Figure 45 (c).
Insert the thermometer into its holder. Figure 45 (d).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 45 (e).
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.
Figure 45
Figure 44