Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
12
Figure 4
Bushings down
Dimples to
the inside
Fuel scale
decal
Only start
this bolt
Figure 3
Wheel
frame
Caster
frame
Step 4
Continue frame assembly
You will need: frame assembly, wheel frame assembly,
front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four
nylon washers and a 7/16 inch wrench.
Place the caster frame onto the tabs of the left frame with
the dimple to the inside. Figure 3. Place the wheel frame
onto the tabs of the right frame with the dimple to the
inside. The fuel scale decal should face away as shown.
Figure 3.
The leg tabs must be on the inside of the frames.
Add front panel with the hole down and to your right. Add
the washers to the bolts, insert in the holes as shown.
Only start the bolts at the wheel frame, figure 3 (a) & (b),
and tighten the bolts at the caster frame.
Note - Fuel scale decal on wheel frame must be on the
same side as the front panel.
Step 5
Complete frame assembly
You will need: partial frame assembly, one frame
connector with bushings, one frame connector without
bushings, four 1/4-20 x 2 inch bolts, four nylon washers
and a 7/16 inch wrench.
Hold the frame connector, bushing side down, between
the caster and wheel frame, above the front panel. Add
nylon washers to the bolts, put the bolts through the frame
and screw into the frame connector. Tighten.
The second frame connector has no bushings, place it
between the caster frame and the wheel frame. Add a
nylon washer to the bolt, put the bolts through the frame
and screw into the frame connector. Tighten. Figure 4.