Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
26
Insert in
frame brace
Tool holders
(a)
(b)
Phillips screws/
washers
Side view
View from top
Step 29
Install tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel, two Phillips
screws/washers, a Phillips screwdriver, and three burner
control knobs.
Hook the tool holders over the frame rail. Figure 42.
Set the control panel in place over both frame braces. (Hold
the Crossover Ignition button up while setting the control
panel in place.) Line up the holes in the control panel with
the holes in the inserts in the frame brace. Insert screws
and tighten with a Phillips screwdriver until snug. Do not
overtighten. Figure 42 (a).
Push on the burner control knobs. Figure 42 (b).
Step 30
Secure the side burner
Pull the right hand swing table up. Stand to the right side
of the barbecue. Slightly pull back both side burner locks.
Slide the side burner toward the control panel. The locks
will snap into the slots in the front and back of the side
burner. Figure 43.
ƽCAUTION: Make sure both locks have snapped
into place.
Figure 42
Figure 43
Crossover
Ignition Button