Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
21
Figure 27
Figure 28
View from rear
of barbecue
Hinge rod
Figure 29
F
F
Notch
Slide bar
Unlocked position
Slide
Support rod
Locked position
Wheel frame
View from front
of barbecue
Slot in frame
(view from below)
(b)
(c)
(a)
To lower table: Pull support rod up to disengage slide lock
and lower table. To raise table, lift table up and engage
slide in locked position. Figure 29.
Insert one end of the hinge rod into the hole in the frame.
Figure 27 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 27 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 27 (c).
To fully seat the bracket, you may have to tap it lightly with
a hammer.
ƽWARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Contact
your dealer to order a new part.
ƽWARNING: The load limit for the swing table is
30 pounds.
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 28.