Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7
Cover Assembly
5. Install support tube (A, Figure 12) inside the box.
Align each end of the support tube with the two holes
at the front corner side of the box. Place one 5/16-18
x 1-1/2 hex bolt with a 5/16 flat washer and plastic
spacer through the top, outside hole of the box and
the support tube. Secure with a 5/16 locknut on the
inside. At the bottom hole place on 5/16-18 x 1 -1/2
hex bolt with a 5/16 flat washer through the box and
the support tube. Secure with a 5/16 locknut.
COVER ASSEMBLY
1. Refer to Figure 13. Unfold the cover and spread it out
on a flat, clean surface with the white dust shield side
up. The two 3/8 inch rods are threaded through two
sleeves inside the cover. The rod with the two bent
ends is called the frame rod (B), since it lays on top
of the box's frame. The rod with the two eyebolt ends
is called the support rod, since it supports the top,
rear side of the cover.
2. Thread the frame rod through the bottom sleeve of
the cover so that the two bent ends protrude through
the openings on each side. The openings (A) of the
sleeve are found next to the black cord loops.
3. Thread the support rod (A, Figure 14) through the
sleeve inside the cover.
4. Pick up the cover by holding the rods and place the
support rod inside the frame rod before hooking the
frame rod (A, Figure 19) through the eyelet of the
support rod (B) on each end.
5. Place the cover assembly over the support tube.
Insert the frame rod with the support rod attached
through the hole in the support tube and secure with
a flat washer (13/32 I.D., 7/8 O.D.) and safety clip (A,
Figure 16) on each side.
Figure 14. Install Support Rod
A. Support Rod
Figure 15. Connect Frame Rod and Support Rod
A. Frame Rod B. Support Rod
Figure 16. Secure Rods
A. Safety Clip
Figure 12. Install Support Tube
A. Support Tube
Figure 13. Install Frame Rod
A. Opening B. Frame Rod