Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Before First Use
1. Remove the Grill and any packaging materials.
2. Place the Base Frame on a flat, level surface.
3. Lift off the Side Trays and set them to the side. Disconnect the Storage
Arms from the Wheel/Leg Frame to allow access to the Grill Assembly.
4. Remove the Grill Plate, Grill Base, Lid and Drip Tray. Wipe the Grill Base and
Lid with a damp cloth to remove any dust. Wash the Grill Plate and Drip
Tray in warm, soapy water. Rinse
and dry thoroughly.
5. The Handle/Vent and mounting
hardware, (Screw/Washer) are
shipped in an inverted fashion,
requiring minor assembly.
Remove the Handle/Vent from
the inside of the Lid by unscrew-
ing the Screw/Washer. Remove
all parts, then properly position
the Handle/Vent on the top of the
Lid. Make sure the Handle/Vent stop pin enters the Vent slot in the Lid. From
the inside of the Lid, place the Screw/Washer through the hole in the Lid
and Handle/Vent. Securely fasten with a Phillips head screw driver. See
Figure 1.
6. Slide the Drip Tray into the slots in the Grill Base.
7. See "Grilling Positions" on the following pages and place the Grill Base on
the Base Frame.
8. Place the Grill Plate on the Grill Base and place the Lid over the Grill Plate.
Grill Positions
The Wheel-It and Grill-It
™
Portable
Propane Grill is compact enough to
transport to any grilling location.
Wheel-It from the storage shed to the
patio, to a picnic in the park, or off on
a camping trip. The Portable Propane
Grill easily transforms from storage to
transport and to high or low Grill-It
positions.
Storage Position: This position
makes the Grill compact enough for
space saving storage. The Side Trays
are stored on the Leg Assemblies and
the Transport Handle slides into the
top of the Frame.
7
Screw/Washer
Handle/Vent
Lid
Vent Slot
Figure 1
Figure 2
GP200RED IB_13-4-02 13/4/02 14:12 Page 14