Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Step 1: Connect the Tank Locking Bar (Fig. 10)
1. From box Column Box locate and attach the Tank Lock
Bar across the back of the pedestal column. Use the ¾"
S.S. Hex bolt, Nylon Lock Bar Spacer and a Kep nut on
each side to fasten the Tank Lock Bar in place. This
spreads and holds the correct spacing at the back of the
column.
Stainless Steel and Aluminum Column
To Base Kit Assembly Instructions
The A30 or A40 grill heads may be mounted on either
the Stainless Steel (A-S PED) or Black Aluminum (A-B
PED) column.
The gas supply may be LP or Natural as determined
by the grill head.
The grill head should not be attached to the column
until the column and the base kit (A-NB, A-LC or A-NC)
is assembled together.
Please check to be sure that all parts are included before
proceeding. Contact your dealer if any parts are missing.
Parts Quantity
Column Box
Stainless Steel Front Panel 1
Stainless Steel or Aluminum Column 1
Stainless Grease Cup 1
Tank Lock Bar 1
Hardware Kit
Nylon Lock Bar Spacers 2
¼ - 20x1¼" S.S. Hex Head Bolts 4
¼ - 20 S.S. KEP Nuts 12
¼ S. S. Washers 10
¼ - 20 x ¾" S.S. Hex Bolts 8
Rectangular Washers 4
2-piece Gasket (Stainless Steel Column Only) 1
Aluminum Reinforcing Bar (Alum. Column Only) 2
Step 2: Attach the Base to the Pedestal (Fig. 11)
1. Before bolting the pedestal column to the base, the 2-
piece gasket
(stainless steel column only) must be installed to
create a barrier between the two metals. Remove the
backing strips from the gasket to expose the adhesive
and stick the gasket to the bottom lip of the pedestal
column. Make sure to align the holes.
2. Attaching the pedestal column to the base will be easier to
handle by laying the pedestal column face down and
matching the holes on the pedestal column lip to the
holes on the base. Use six ¾” bolts, four large
rectangular washers, and on the underside six round
washers and KEP nuts.
IMPORTANT: the large
rectangular washers are used at the sides on top of the
pedestal column lip. The round washers and KEP nuts
are used under the base. Tighten securely and stand unit
upright.
Parts Quantity
Base Box
Cast Aluminum Base 1
12’ Nat. Gas Hose/Quick Disconnect Hose 1
Above In A-NC Base Kit Only
16” Hose & LP Regulator (In A30 or A40 LP Head)
Stainless Steel Flexible Tubing, 28” 1
Above In A-NB Base Kit Only
Axle 1
Axle Clips 2
6 " Wheels 2
Hub Caps 2
Rotating Casters 2
Above 5 items in A-NC or A-LC Base Kit Only
Note: While assembling, peel the thin white protective
film covering from the stainless steel surfaces,
especially in areas, which will be partially hidden after
assembled. Do Not Scrape off.
13