Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
NG Regulator Hose and Regulator Conversion
Tools required:
/_ WARNING
Phillips Head Screwdriver (+)
Monkey Wrench
Make sure all grill components are completely cooled and gas supply is turned off and removed
from grill prior to performing the conversion.
1. Install the regulator hose (short hose) to the end of the regulator marked "OUT."
Install the brass connector to the other end of the regulator marked "IN." (If regulator,
hose, and brass connector are pre-assembled, you may disregard this step.)
2. Turn all knobs to OFF. Turn off LP gas supply and remove the LP cylinder from the grill cart.
Remove the brass adapter of the LP regulator from the manifold with a wrench.
3. Install the NG regulator hose to the manifold and secure using a wrench.
4. Remove two screws and washers from the regulator then tighten NG regulator on the
right side panel from inside to outside.
15