Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
www.napoleongrills.com
WARNING! Hose: Check for abrasions, melng, cuts, and cracks in the hose. If any of these condions
exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill dealer or qualied gas
installer.
WARNING! When reinstalling the burner aer cleaning it is very
important that the valve/orice enters the burner tube before lighng your
gas grill. If the valve is not inside the burner tube a re or explosion could
occur.
Aluminum Casngs: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white spots
on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding areas from over-
spray. Follow the manufacture’s direcons for curing.
Protecon Of Infrared Burners: The infrared burners of your grill are designed to provide a long service life,
though care must taken to prevent cracking of their ceramic surfaces. Fractures will cause the burners to
malfuncon. The following provides a few of the causes of cracks and the steps you can take to avoid them.
Damage caused by failure to follow these steps is not covered by your grill warranty.
1. Impact with hard objects - Never allow hard objects to strike the ceramic. Take care when inserng or re-
moving cooking grates and accessories into or from the grill.
2. Contact with water or other liquids - Cold liquids contacng the hot ceramic surfaces can cause them to
break. Never throw water into the grill to douse a ame. If the ceramic or interior of a burner becomes wet
while not in use, later operaon of the burner can create steam, which can produce sucient pressure to crack
the ceramic. Repeated soaking of the ceramic can also cause it to swell and expand. This expansion causes
undue pressure on the ceramic that can cause it to crack and crumble.
i) Never throw water into the grill to control are-ups.
ii) Do not aempt to operate the infrared burners in open air while raining.
iii) If you nd standing water in your grill (because of exposure to rainfall, sprinklers, etc.), inspect the
ceramic for evidence of possible watersoaking. If the ceramic appears to be wet, remove the burner from the
grill. Turn it upside down to drain the excess water and bring indoors to dry thoroughly.
3. Impaired venlaon of hot air from the grill - For the burners to funcon properly, hot air must have a way
to escape the grill. If the hot air is not allowed to escape, the burners can become deprived of oxygen causing
them to back-ash. If this occurs repeatedly, the ceramic could crack. Never cover more than 75% of the cook-
ing surface with solid metal (i.e., griddle or large pan).
4. Incorrect cleaning - Do not clean the ceramic le with a wire brush. If debris is collecng on your burner,
light the burner and operate on high for 5 minutes with the lid open, allowing debris to burn o.
the burner installed. Do not ex the drill bit when drilling the ports, as this will cause the drill bit to break. This
drill is for burner ports only, not for the brass orices (jets) which regulate the ow into the burner. Take care
not to enlarge the holes. Ensure the insect screen is clean, ght, and free of any lint or other debris.
Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace sear plate mount and ghten screws to complete reinstallaon.
REPLACEMENT SCREEN N565-0002