Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
OPERATING AND MAINTAINING YOUR GAS GRILL
GAS, CYLINDER, HOSE AND
REGULATOR INFORMATION
This LP gas grill was designed to use propane gas. Propane
cylinders will supply gas all year round, even on cold winter
days.
LP HOSE AND REGULATOR ASSEMBLY
· Using a hose and regulator assembly that has
not been supplied by the manufacturer of this LP
gas grill, could result in serious bodily injury
or property loss.
· Use only the hose and regulator assembly that has been
furnished with this LP gas grill. If the hose and regulator
assembly is not working properly and you need a
replacement, contact the manufacturer (1-800-251-7558).
· Inspect the hose before each use. If the hose is cut or
damaged or shows signs of excessive abrasion or wear,
do not use the LP gas grill. Contact the manufacturer, as
the hose must be replaced with an assembly specified by
the manufacturer prior to the further use of the LP gas grill.
1) 12” diameter x 18” tall, 20 lb maximum capacity
2) Overfill Protection Device (OPD) safety feature (should
be noted on cylinder)
3) Must be constructed and marked in accordance with
the U.S. Department of Transportation (DOT) or the
National Standard of Canada, CAN\CSA-B339. (See
collar for marking)
4) Must have collar to protect LP cylinder valve.
· Never use an LP gas cylinder if it shows signs of: dents,
gouges, bulges, fire damage, corrosion, leakage,
excessive rust or other forms of visual external damage; it
may be hazardous and should be checked by a liquid
propane supplier.
· The LP gas cylinder should never be filled more than 80%
of cylinder volume. (20 lb. maximum) Do not ask the
propane supplier to over-fill the cylinder.
· If you obtain LP gas through a cylinder exchange dealer,
make sure you are getting a safe and adequate O.P.D.
cylinder. Use only a licensed LP gas cylinder dealer.
· Keep children away from LP gas cylinder at all times.
· Do not use, store, or transport the LP gas cylinder where it
would be exposed to high temperatures. The relief valve
may open which will allow a large amount of
flammable gas to escape. Never leave an LP gas cylinder
inside a vehicle which may become overheated by the
sun.
· WARNING! Never store an LP cylinder indoors.
Storage of an outdoor cooking gas appliance indoors is
permissible only if the cylinder is disconnected and re-
moved from the outdoor cooking gas appliance. Cylinders
must be stored outdoors out of the reach of children and
must not be stored in a building, garage, or any other
enclosed area.
· WARNING! Never store a spare LP gas cylinder
under or near the grill. All spare and disconnected
LP gas cylinders must have safety caps installed on the
LP cylinder valve.
· LP gas is not natural gas. The conversion or attempted
use of natural gas in an LP unit or LP gas in a natural gas
unit is dangerous and will void your warranty.
· Never attempt to repair an LP gas cylinder valve yourself.
See an authorized LP gas cylinder dealer for repairs.
· When transporting an LP gas cylinder, keep it secured in
an upright position with cylinder valve turned to off
· Do not operate the LP gas grill when the LP gas
cylinder is not attached to the cart as shown in the Asse
mbly Instructions.
· Always check for gas leaks when you
disconnect and reconnect the regulator to the LP
gas cylinder, especially after a period of storage (for
example, over winter).
· Check tubes that lead into the burner for
any blockage from insects, spiders, or food
grease before using.
· Check grill hoses for cracking, brittleness, holes,
or leaks.
· Make sure there are no sharp bends in the hose or
tubing.
· Make sure Regulator Hose does not contact
hot metal surfaces.
22
Connecting/ Disconnecting LP
Gas Cylinder to Grill
· Read and follow all warnings on LP gas cylinder.
· If you see, smell, or hear the hiss of LP gas
escaping from the cylinder:
1) Evacuate all people from the grilling area.
2) Do not attempt to correct the problem
yourself.
3) Call the local fire department.
LP Gas Cylinder
· The LP gas cylinder, for use with the Aussie LP gas grills,
must meet the following requirements: